(flow/EM)īut I will miss the multibed layout!!! Superslicer sir!!!! you hear me?įor example, if you switch a nozzle diameter in SS, because all lines and flows are in percentage to this diameter, you dont have to set anything else, in Orca you have to set EVERY line width separately. I just find it responses better to my tuning than Orca somehow. I also have issues with some travel that happens over infill and scratches the surface, I dont know why there is no Zhop happening, but there is something weird happening.Īll in all, SS is just aas fast for me, but its waaaay more smooth of a print in sound, and parts look better too. I love the project with multiple plates setup, other thinks that are ok is the layout but it still has the same pain as SS, and I think I can tune better n SS than in Orca.īut best reason, in Orca I cant get my prints to look perfect, while I can in SS. It's not much of a change, but just enough between the 0.4 and 0.15 nozzle (about 0.015mm) that it goes from a perfect layer to just dragging the tip on the plate.Īfter giving it a lot of time and prints, Im back to Superslicer. I've tried putting in a M290 instruction in the start gcode in Orca, but it doesn't seem like the Mini's Marlin is honoring that command. ![]() The live Z calibration changed between nozzles with Tap I don't care since it auto adjusts. That's new behavior since hooking up that feature on Orca. I've had Octoprint drop wifi connection a couple of times bad enough that I had to power cycle the Pi (after the print). While the interface tab is nice, I'm not confident it's super stable. It's also having some trouble with overhangs & the corners on the XY letters. I've copied over my SuperSlicer settings and it's getting there, but still coming a touch under extruded. It's close, but Orca's speeds just don't go well with the tiny orifice. ![]() I'm trying to get the 0.15mm nozzle dialed in and that's proving tougher. At least on the Revo-equipped Mini so far the 0.4mm nozzle calibration is good calibration cubes look about the same.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |